I was working in the Heating plus A/C appliance control room at the hospital on Thursday, when the red lights on floor 27 plus 28 started to flash.
The red lights signify when the heat is not operating. I honestly thought it was pretty strange that the heat wasn’t working just on floor 27 plus 28, so I reached out to the floor doctor in each of these areas. I had both of the doctors check numerous different rooms plus both ends of the hallway. The heat seemed to be working perfectly plus the warm air was flowing out of the air vents without any issues. Since the heat was working great, I right away knew there must be a setback with the PC program or the sensors. This particular hospital has a building management plan for all of the heating, AC, plus Lighting. Someone is regularly in the control room to look over the technology equipment. I waited to see if the complication would actually take care of itself, but the red light continued to flash for a long while. Since the heat was still working, I made the choice to wait until later to inform my boss. There was no reason to wake him up at 5 in the morning when the heat was actually still working… When my boss got to the place after 7, he right away got started on the drawback. My shift was over plus I went back to my dwelling. I have no clue in the slightest why the software was glitching in such a way, but I came back to task the next night plus everything was working great. It’s been four days plus I have not had any other malfunctions, so the problems must be fixed completely.